Aerospace Grade Fire Sleeve

Aerospace Grade Fire Sleeve

AerostyleFiresleeveis constructed from a high bulk E fibreglass fibre that is braided to produce a hollow sleeve. Braid architecture to allow finished coated product to be slightly expandable where necessary. It is coated with a thick covering of iron oxide red silicone rubber.

Oil and Fluid Resistance: Impervious to most liquids including those with a hydrocarbon base. Remains functional after immersion for 120 hours at 80°F in MIL-L-6082 and Skydrol500.

In addition to protecting hoses, cables and pipes etc., AerostyleFiresleevecan protect people from incurring scorching burn injuries on hot braided hoses and pipes.

AerostyleFiresleeve’sexcellent moisture resistance makes it ideal for use outdoors.

Dimensional Data:

  • Available in diameters from 1/4" (6mm) to 6" (152mm).
  • Standard lengths are 50ft (15mtrs) and 100ft (30 mtrs).
  • Nominal wall thickness: 0.142" ( 3.61mm)


Allow tolerance to install over hoses or cable. Both length and co-efficient of friction should be taken into account when determining correct diameter.

Continuous Operating Temp °C
Rated for 500°F (260°C) to -65°F (-54°C)
Temperature Capabilities
up to 2000°F ( 1093°C) for 15-20 minutes
Maximum Temperature
up to 3000°F ( 1650°C) for 15-30 seconds

Related Sleeve It Products

Aerospace Grade Fire Sleeve

Therm It GS 10 glass fibre rope seal is manufactured from continuous filament 'E' type glass yarns which have been mechanically bulked to increase the loft. 'E' type glass fibre...

Aerospace Grade Fire Sleeve

SBRM is based on muscovite mica paper bonded with a heat resistant silicone resin. The cured laminate has good mechanical and thermal properties. Suitable for a wide variety of operating conditions,...

Aerospace Grade Fire Sleeve

SBGL is a high temperature, high electrical strength insulation material, fire resistant. What’s it used for? Furnace insulation. Microwave applications. Hot melt splash...